Removal and Installation Removal NOTE:Removal steps in this procedure may contain installation details. | -
NOTE:This step requires the aid of another technician. | | -
NOTE:This step requires the aid of another technician. | | -
Remove the loadspace trim panel, on both sides. Refer to: Loadspace Trim Panel - Convertible (501-05 Interior Trim and Ornamentation, Removal and Installation). | | -
CAUTION:Note the routing of the lines and hoses. CAUTION:Make sure that the component is not bent. NOTE:Note the position of each component before removal. | | -
CAUTION:Make sure that the component is not bent. | Installation | -
To install, reverse the removal procedure. | | -
Align the luggage compartment lid. Refer to: Convertible Top Alignment (501-18 Convertible Top, General Procedures). | | -
Initialize the door window motors. Refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures). | | -
-
Operate the convertible top switch to the down/open position until the convertible top is fully open. -
Operate the convertible top switch to the up/closed position until the convertible top is fully closed. | | |