Removal and Installation General Equipment Worldwide Diagnostic System (WDS) Removal WARNING:The supplemental restraint system (SRS) is active for a certain length of time after the power supply has been disconnected. Wait for a minimum of 3 minutes before disconnecting or removing any SRS components. WARNING:Make sure that the vehicle electrical system is fully depowered and no other power source is connected. WARNING:Do not probe supplemental restraint system (SRS) electrical connectors. WARNING:Refer to: Supplemental Restraint System (SRS) Health and Safety Precautions (100-00 General Information, Description and Operation). NOTE:Removal steps in this procedure may contain installation details. | -
Disconnect the battery ground cable. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures). | | -
Remove the floor console. Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation). | Installation | -
To install, reverse the removal procedure. | | -
When a new restraints control module is installed, configure the restraints control module. | |