ford Workshop Repair Guides

Ford Focus RS Workshop Service and Repair Manuals

ABOUT US
Power Steering Fluid Cooler - 2.0L Duratec-RS (Zetec) > < Power Steering Pump to Steering Gear Pressure Line - 2.0L Duratec-RS (Zetec)

Focus RS 2003 Power Steering Pump - 20L Duratec-RS (Zetec)

Power Steering - Power Steering Pump—2.0L Duratec-RS (Zetec) Focus RS 2003 (09/2002-)
Removal and Installation

Special Tool(s)

Expander, Teflon Seal

211-188 (13-015)
General Equipment
Brake hose clamp

Removal

  1. Remove the accessory drive belt. For additional information, refer to Section  303-05 Accessory Drive.
  1. Remove the right-hand headlamp assembly. For additional information, refer to Section  417-01 Exterior Lighting.

  1. Detach the power steering line from the engine.
  1. Using a suitable brake hose clamp, clamp the power steering fluid reservoir to power steering pump hose.

  1. Disconnect the power steering hose from the power steering pump.
    • Allow the fluid to drain into a suitable container.

  1. Disconnect the power steering line from the power steering pump.
    • Allow the fluid to drain into a suitable container.

  1. Remove the power steering pump lower retaining bolts.

  1. Remove the power steering pump.

Installation
  1. NOTE:
    NOTE:If installing a new power steering pump, the unions supplied with the new pump should be removed and retained for further use.
    Using the special tool, install a new O-ring seal onto the power steering line to steering pump union.
    1. Push the O-ring seal onto the special tool.
    1. Locate the special tool onto the union and install the O-ring seal.
  1. To install, reverse the removal procedure.
  1. Fill and bleed the power steering system. For additional information, refer to Section  211-00 Steering System - General Information.

Power Steering Fluid Cooler - 2.0L Duratec-RS (Zetec) > < Power Steering Pump to Steering Gear Pressure Line - 2.0L Duratec-RS (Zetec)