Ford Workshop Service and Repair Manuals

Remover, Crankshaft Oil Seal

303-293 (21-143)

Installer, Crankshaft Oil Seal

303-395 (21-171)

Installer, Crankshaft Oil Seal

303-684 (21-243)

1. Remove the timing belt.
   For additional information, refer to Timing belt - in this section.
   

2. 

   NOTE:FRONT marking and installation position of the timing pulley thrust washer.
   Remove the crankshaft timing pulley.
   1. Pull off the crankshaft timing pulley.
   2. Remove the timing pulley key and thrust washer.

3. Remove the crankshaft front oil seal.

1. 

   NOTE:Correct seating of sealing lip on the installation sleeve.
   Push crankshaft front oil seal to approx. the middle position on the special tool.

2. Push the special tool fully home onto the crankshaft.

3. Push the crankshaft front oil seal by hand, over the special tool, until it is fully home on the oil seal carrier, on the crankshaft.

4. Remove the special tool.

5. 

   NOTE:Use the bolt of the crankshaft vibration damper.
   Draw in the crankshaft front oil seal using the special tool to the fully home position.

6. 

   NOTE:FRONT marking and installation position of the timing pulley thrust washer.
   Install the crankshaft timing pulley.
   1. Push on the timing pulley thrust washer and key.
   2. Attach the crankshaft timing pulley.

7. Install the timing belt.
   For additional information, refer to Timing belt - in this section.