ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Accelerator Cable - 2.0L Duratec-ST (Zetec) RHD > < Accelerator Cable - 2.0L Duratec-RS (Zetec)

Focus RS 2003 (09.2002-)

Acceleration Control - Accelerator Cable—2.0L Duratec-ST (Zetec) LHD Focus RS 2003 (09/2002-)
Removal and Installation

Removal
  1. Remove the snow cover from the throttle body.

  1. Detach the accelerator cable from the throttle body.
    1. Remove the retaining clip and detach the inner cable from the throttle body.
    1. Rotate the outer cable.
  1. Detach the accelerator cable from the retaining clip.

  1. Remove the footwell trim panel.

  1. Disconnect the accelerator cable from the pedal.

  1. Attach a draw cord to the accelerator cable to assist with installation.
  1. Remove the accelerator cable.

Installation

  1. NOTE:
    NOTE:The rubber grommets must be installed into the bulkhead and throttle body bracket before the accelerator cable is installed into the grommets.
    To install, reverse the removal procedure.

Accelerator Cable - 2.0L Duratec-ST (Zetec) RHD > < Accelerator Cable - 2.0L Duratec-RS (Zetec)