Freestar V6-4.2L VIN 2 (2004)
9. Remove the dual lock windshield glass stop adhesive backing.
10. Apply urethane glass primer to the same area that was prepped in the previous step. Allow five minutes to dry.
11. Cut the urethane adhesive applicator tip to specification.
12. Apply a bead of urethane adhesive to the pinch weld.
13. CAUTION: Open the windows to prevent the windshield glass from being pushed out by air pressure if a door is closed.
Install the windshield glass on the pinch weld. Align the windshield glass to the body using the alignment marks while pushing downward to set
the stops.
14. Inspect the windshield glass installation for air or water leaks and add urethane adhesive where needed.
15. Place 2 strips of duct tape onto the windshield glass and secure it to the roof panel. This will help avoid misalignment while the urethane cures.
