Fusion FWD L4-2.3L VIN Z (2007)
All vehicles
14. CAUTION:
-
The FP module must be handled carefully to avoid damage to the float arm.
-
The FP module will have residual fuel remaining internally, drain into a suitable container.
Completely remove the FP module from the fuel tank.
15. CAUTION:
-
Inspect the mating surfaces of the FP module flange and the fuel tank O-ring seal contact surfaces. Do not polish or adjust the O-ring
seal contact area of the fuel tank flange or the fuel tank. Install a new FP module or fuel tank if the O-ring seal contact area is bent,
scratched or corroded.
-
Make sure to install a new FP module O-ring seal. Install a new lock ring if it is bent, damaged or corroded.
NOTE: To install, apply clean engine oil to the O-ring seal.
Remove and discard the FP module O-ring seal.
16. To install, reverse the removal procedure.
-
Make sure the alignment tab on the FP module and the fuel tank meet before tightening the FP module lock ring.