Fusion FWD L4-2.5L Hybrid (2010)
No
INSTALL the removed fuses. If the vehicle is equipped with an Accessory Protocol Interface Module (APIM) , GO to AD15.
If the vehicle is not equipped with an APIM,GO to AD16.
-------------------------------------------------
AD15 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE APIM DISABLED
-
Disconnect: SJB Fuse 13 (5A) .
-
Enter the following diagnostic mode on the scan tool: Network Test .
-
Repeat the network test.
-
Do all other HS-CAN modules pass the network test?
Yes
INSTALL the removed fuse. GO to Pinpoint Test AA. See: Pinpoint Test AA: The Accessory Protocol Interface Module (APIM) Does Not Respond To
The Scan Tool
No
INSTALL the removed fuse. GO to AD16.
-------------------------------------------------
AD16 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE OCSM DISABLED
-
Disconnect: SJB Fuse 46 (7.5A) .
-
Enter the following diagnostic mode on the scan tool: Network Test .
-
Repeat the network test.
-
Do all other HS-CAN modules pass the network test?
Yes
INSTALL the removed fuse. GO to Pinpoint Test F. See: Pinpoint Test F: The Occupant Classification System Module (OCSM) Does Not Respond To
The Scan Tool
No
INSTALL the removed fuse. If the vehicle is equipped with a Transmission Control Module (TCM), GO to AD17.
If the vehicle is not equipped with a TCM, GO to AD18.
-------------------------------------------------
AD17 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE TCM DISABLED
-
Disconnect: Gasoline Engine - SJB Fuse 44 (10A) and BJB Fuse 16 (5A) .
-
Disconnect: Hybrid - TCM C1458a .
-
Enter the following diagnostic mode on the scan tool: Network Test .
-
Repeat the network test.
-
Do all other HS-CAN modules pass the network test?
Yes
INSTALL the removed fuses (gasoline engine) or CONNECT the TCM (hybrid). GO to Pinpoint Test G. See: Pinpoint Test G: The Transmission
Control Module (TCM) Does Not Respond To The Scan Tool
No
INSTALL the removed fuses (gasoline engine) or CONNECT the TCM (hybrid). GO to AD18.