ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3024 > < Initial Inspection and Diagnostic Overview|Page 3022
Page 55
background image

No

GO to R35.

-------------------------------------------------
R35 VERIFY VEHICLE EQUIPMENT - PAM

-

Inspect the vehicle for a Parking Aid Module (PAM).

-

Is the vehicle equipped with a PAM?

Yes

GO to R36.

No

GO to R37.

-------------------------------------------------
R36 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE PAM DISCONNECTED

-

Disconnect: PAM C4014.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to R52.

No

GO to R37.

-------------------------------------------------
R37 VERIFY VEHICLE EQUIPMENT - DDM

-

Inspect the vehicle for a Driver Door Module (DDM).

-

Is the vehicle equipped with a DDM?

Yes

GO to R38.

No

GO to R39.

-------------------------------------------------
R38 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE DDM DISCONNECTED

-

Disconnect: DDM C568a.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

Initial Inspection and Diagnostic Overview|Page 3024 > < Initial Inspection and Diagnostic Overview|Page 3022