Fusion FWD V6-3.5L (2010)
Power Steering Fluid Reservoir: Service and Repair
Power Steering Fluid Reservoir - 3.5L
Removal and Installation
NOTICE: When repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power
steering components may result.
1. Using a suitable suction device, remove the power steering fluid from the fluid reservoir.
2. Release the clamp and disconnect the power steering return hose from the power steering fluid reservoir.
3. Remove the 3 power steering fluid reservoir bracket bolts.
-
To install, tighten to 7 Nm (62 lb-in).
4. Release the power steering pump supply hose clamp and disconnect the supply hose from the reservoir.
5. NOTE: If a new power steering fluid reservoir is being installed, a new reservoir mounting bracket must also be installed.
Remove the power steering fluid reservoir and bracket as an assembly.
6. To install, reverse removal procedure.
7. Fill the power steering system. For additional information, refer to Steering.
