Fusion FWD V6-3.5L (2010)
6. Disconnect the 2 wiring harness fasteners and position the RCM wiring harness aside.
7. Position the insulation blanket away from the bulkhead to gain access to the 2 selector lever cable bracket nuts.
8. Remove the 2 selector lever cable grommet nuts and remove the selector lever cable through the interior of the vehicle.
Installation
1. Position the selector lever cable in place and install the 2 nuts.
-
Tighten to 9 Nm (80 lb-in).
2. Position the insulation blanket in place over the selector lever cable grommet.
3. Position back the RCM wiring harness and install the fasteners on the studs.
