Fusion FWD V6-3.5L (2010)
Installation
1. NOTICE: Make sure to install the correct circlip for each application. Failure to use the correct diameter circlip may result in shaft
removal concerns or shaft separation during vehicle operation.
Install a new circlip on the stub shaft.
2. Using the Axle Seal Protector, install the halfshaft into the differential.
-
Make sure the circlip locks in the side gear.
3. Using the Halfshaft Installer, install the halfshaft into the hub assembly.
4. Install the upper arm bolt and nut.
-
Tighten to 110 Nm (81 lb-ft).
5. NOTICE: Do not tighten the rear wheel hub nut with the vehicle on the ground. The nut must be tightened to specification before the
vehicle is lowered to the ground. Wheel bearing damage will occur if the wheel bearing is loaded with the weight of the vehicle applied.
Install the new wheel hub nut.
-
To install, tighten to 255 Nm (188 lb-ft).
6. Stake the new nut in line with the keyway to a recommended minimum depth of 1 mm (0.039 in) below the keyway diameter to engage the locking
feature.
