Removal and Installation Removal | -
Detach the coolant expansion tank from the battery shield and position to one side. - Disconnect the low level sensor electrical connector.
- Remove the coolant expansion tank retaining bolts.
| | -
Disconnect the engine wiring harness electrical connector. | | -
Detach the engine wiring harness mounting bracket from the battery shield. | | -
Remove the battery side cover. - Detach the coolant expansion tank hose from the battery side cover.
- Remove the battery side cover retaining bolts.
| | -
Detach the battery junction box (BJB) from the front bulkhead assembly. - Remove the BJB retaining screws.
- Slide the BJB towards the rear of the vehicle.
| | -
Detach the battery front side cover from the front bulkhead assembly. | | -
Remove the power steering fluid reservoir retaining bolt. | | -
Disconnect the power steering fluid reservoir return line. - Allow the fluid to drain into a suitable container.
| | -
Remove the power steering fluid reservoir. - Disconnect the power steering fluid reservoir supply hose.
- Remove the power steering fluid reservoir.
| Installation | -
To install, reverse the removal procedure. | | |