ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Valve Seals > < Valve Cover

Galaxy 2000.75 (04.2000-02.2006)

Engine - 2.0L - Crankshaft Rear Seal Galaxy 2000.75 (04/2000-02/2006)
In-vehicle Repair

Special Tool(s)

Locking Tool, Flywheel

303-254 (21-135)

Installer, Crankshaft Rear Oil Seal

303-291 (21-141)

Remover, Crankshaft Rear Oil Seal

303-336 (21-151)
General Equipment
Two M10 x 80 mm bolts
Three self tapping screws

Removal

  1. Remove the clutch disc and pressure plate. For additional information, refer to Section  308-01 Clutch.

  1. Using the special tool, lock the flywheel in position.

  1. Remove the flywheel.
    • Discard the bolts.

  1. Using the special tool, make pilot holes in the crankshaft rear oil seal.

  1. Using three suitable screws, install the special tool.
  1. Using the special tool, remove the crankshaft rear oil seal.
    • Discard the oil seal.

Installation
  1. Using the special tool and two old flywheel bolts, install the crankshaft rear oil seal.

  1. NOTE:
    NOTE:Install new flywheel bolts.
    NOTE:
    NOTE:Do not fully tighten the flywheel bolts at this stage.
    Install the flywheel.

  1. Using the special tool, lock the flywheel in position.

  1. Tighten the flywheel bolts.
  1. Remove the special tool.
  1. Install the clutch disc and pressure plate. For additional information, refer to Section  308-01 Clutch.

Valve Seals > < Valve Cover