ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Crankshaft Rear Seal > < Crankshaft Front Seal

Galaxy 2000.75 (04.2000-02.2006)

Engine - 2.0L - Valve Cover Galaxy 2000.75 (04/2000-02/2006)
In-vehicle Repair

Removal

  1. Disconnect the battery ground cable. For additional information, refer to Section  414-01 Battery, Mounting and Cables.
  1. Remove the air cleaner. For additional information, refer to Section  303-12 Intake Air Distribution and Filtering.

  1. Detach the positive crankcase ventilation (PCV) hose from the power supply rail.

  1. Disconnect the camshaft position (CMP) sensor electrical connector.

  1. Disconnect the power supply rail from the fuel injectors.

  1. Remove the valve cover
    • Discard the gasket.

Installation
  1. NOTE:
    NOTE:Install a new valve cover gasket.
    Install the valve cover.
    • Tighten the nuts and bolts in the sequence shown in two stages.
    • Stage 1: Tighten nuts and bolts 1 through 15 to 3 Nm.
    • Stage 2: Tighten nuts and bolts 1 through 15 to 9 Nm

  1. Connect the CMP sensor electrical connector.

  1. Connect the power supply rail to the fuel injectors.

  1. Attach the PCV hose to the power supply rail.
  1. Install the air cleaner. For additional information, refer to Section  303-12 Intake Air Distribution and Filtering.
  1. Connect the battery ground cable. For additional information, refer to Section  414-01 Battery, Mounting and Cables.

Crankshaft Rear Seal > < Crankshaft Front Seal