In-vehicle Repair Removal | -
Remove the spark plug cover. | | -
Disconnect the spark plug wires from the spark plugs. | | -
Disconnect the camshaft position (CMP) sensor electrical connector. | Installation | -
NOTE:Install a new valve cover gasket. Install the valve cover (4 nuts and 11 bolts). - Tighten the nuts and bolts in the sequence shown in two stages.
- Stage 1: Tighten nuts and bolts 1 through 15 to 3 Nm.
- Stage 2: Tighten nuts and bolts 1 through 15 to 9 Nm
| | -
Connect the CMP sensor electrical connector. | | -
Using a suitable blunt object to avoid damage to the spark plug connector gasket, coat the inside of the spark plug connector with silicone grease to a depth of 5-10 mm. | | -
CAUTION:Connect the spark plug wires in line with the spark plugs. Connect the spark plug wires to the spark plugs. | | -
Install the spark plug cover. | | |