ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Rear Side Impact Sensor > < Safety Belt Pretensioner Disposal

Galaxy 2000.75 (04.2000-02.2006)

Supplemental Restraint System - Front Side Impact Sensor Galaxy 2000.75 (04/2000-02/2006)
Removal and Installation

Removal

WARNING:
WARNING:To avoid accidental deployment, the air bag control module backup power supply must be depleted. Wait at least one minute after disconnecting the battery ground cable(s) before commencing any repair or adjustment to the supplemental restraint system (SRS), or any component(s) adjacent to the SRS sensors. Failure to follow these instructions may result in personal injury.
WARNING:
WARNING:To minimize the possibility of premature deployment, do not use radio key code savers when working on the supplemental restraint system. Failure to follow this instruction may result in personal injury.
WARNING:
WARNING:Never probe the electrical connectors of air bag modules or any other supplemental restraint system component. Failure to follow this instruction may result in personal injury.
  1. Disconnect the battery ground cable(s). For additional information, refer to Section  414-01 Battery, Mounting and Cables.
  1. Remove the front seat. For additional information, refer to Section  501-10 Seating.

  1. Remove the floor covering trim panel bracket.

  1. CAUTION:
    CAUTION:Note the position and routing of the wiring harness to aid installation. An incorrectly routed wiring harness may become damaged on the seat mechanism.
    Disconnect the side impact sensor electrical connector.

  1. Remove the front side impact sensor.

Installation

  1. WARNING:
    WARNING:Never probe the electrical connectors of air bag modules or any other supplemental restraint system component. Failure to follow this instruction may result in personal injury.
    To install, reverse the removal procedure.

Rear Side Impact Sensor > < Safety Belt Pretensioner Disposal