Fuel Charging and Controls - 1.3L Endura-E (HCS) - Throttle Body
Ikon 1999 (01/2000-)
Removal and Installation
Removal
CAUTION:Do not attempt to clean the throttle body. The bore and throttle plate have a special coating applied during manufacture which should not be removed.
Remove the accelerator cable clip.
Detach the accelerator outer cable.
Detach the accelerator inner cable.
Disconnect the air cleaner outlet pipe.
Disconnect the throttle position sensor electrical connector.
Remove the throttle body.
Remove and discard the gasket.
Installation
CAUTION:Do not attempt to clean the throttle body. The bore and throttle plate have a special coating applied during manufacture which should not be removed.