ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
303-04B Fuel Charging and Controls - 1.3L Duratec-8V (Rocam)-1.6L Duratec-8V (Rocam)|Specifications > < Fuel Injectors

Ikon 1999 (01.2000-)

Fuel Charging and Controls - 1.3L Duratec-8V (Rocam)/1.6L Duratec-8V (Rocam) - Fuel Charging Wiring Harness Ikon 1999 (01/2000-)
Removal and Installation

Removal

All vehicles
  1. Detach the fuel charging wiring harness and disconnect the electrical connector.

  1. Disconnect the camshaft position (CMP) sensor electrical connector and detach the fuel charging wiring harness.
    • Remove the cable tie.

  1. Detach the fuel charging wiring harness.
    • Remove the cable ties.

  1. Disconnect the fuel injector electrical connectors.

  1. Disconnect the temperature and manifold absolute pressure T-MAP) sensor electrical connector.

  1. Disconnect the idle air control (IAC) valve electrical connector.
Vehicles with manual transmission
  1. Disconnect the throttle position (TP) sensor electrical connector.
Vehicles with automatic transmission
  1. Remove the throttle body.
    For additional information, refer to Throttle Body - Vehicles With: Automatic Transmission in this section.
All vehicles
  1. Disconnect the engine coolant temperature (ECT) sensor electrical connector and remove the fuel charging wiring harness.

Installation

  1. To install, reverse the removal procedure.

303-04B Fuel Charging and Controls - 1.3L Duratec-8V (Rocam)-1.6L Duratec-8V (Rocam)|Specifications > < Fuel Injectors