ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Air Cleaner > < Intake Air Distribution and Filtering

Ikon 1999 (01.2000-)

Intake Air Distribution and Filtering - Air Cleaner Intake Pipe Ikon 1999 (01/2000-)
Removal and Installation

Removal

NOTE:
NOTE:The procedure shown is for vehicles with 1.3L / 1.6L Duratec engine, the procedure is similar for vehicles with diesel engine.
  1. Disconnect the air cleaner outlet pipe from the throttle body.

  1. Disconnect the resonator pipe from the air cleaner outlet pipe.

  1. Remove the air cleaner housing cover and air cleaner outlet pipe.

  1. Remove the air cleaner element.

  1. Disconnect the air cleaner intake pipe from the air cleaner.
    • Release the tang.
  1. Loosen the left-hand front wheel nuts.
  1. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.
  1. Remove the left-hand front wheel.

  1. Remove the left-hand front fender splash shield.

  1. Remove the air cleaner intake pipe.
    1. Rotate the air cleaner intake pipe counterclockwise.
    1. Remove the air cleaner intake pipe.

Installation
  1. To install, reverse the removal procedure.

Air Cleaner > < Intake Air Distribution and Filtering