Fuel Charging and Controls - 1.3L Duratec-8V (Rocam)/1.6L Duratec-8V (Rocam) - Throttle Body
Ka 1997 (09/1996-)
Removal and Installation
Removal
CAUTION:Do not attempt to clean the throttle body. The bore and throttle plate have a special coating applied during manufacture which should not be removed.
Remove the air cleaner outlet pipe from the throttle body.
Remove the accelerator cable retaining clip.
Detach the accelerator cable from the throttle body bracket.
Disconnect the accelerator cable from the throttle body.
Detach the throttle body from the intake manifold.
Disconnect the throttle position (TP) sensor electrical connector and remove the throttle body.
Remove and discard the gasket.
Installation
CAUTION:Do not attempt to clean the throttle body. The bore and throttle plate have a special coating applied during manufacture which should not be removed.