ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Valve Seals > < Intake Manifold

Mondeo 1997 (08.1996-09.2000)

Engine - Vehicles Built From: 05/1998 1.6L/1.8L/2.0L - Valve Springs Mondeo 1997 (08/1996-09/2000)
In-vehicle Repair

Special Tool(s)

Valve spring compressor

303-361 (21155)

Adapter for 21-155

303-361-02 (2115502)

Connector, air supply cylinder

303-363 (21157)

Remover, valve stem oil seal

303-374 (21160)
Materials
Name
Specification
Engine oil
WSS-M2C912-A1 

Removal

  1. Remove the camshafts.
    For additional information, refer to Camshafts in this section.
    • Remove the valve tappets and lay them in order to one side.

  1. WARNING:
    WARNING:Always wear protective goggles when working with compressed air. This can prevent injury.
    Remove the spark plug on cylinder no. 1 and attach the special tool.

  1. CAUTION:
    CAUTION:Use compressed air at 7 to 10 bar.
    Attach the special tool and apply compressed air to the cylinder.
    1. Compress the valve springs.
    1. Remove the valve collets.
    • Remove the valve spring retainers and the valve springs.

Installation
  1. NOTE:
    NOTE:Check that the valve collets are seated properly.
    Install the valve springs.
    • Insert the valve springs and the valve spring retainers.
    1. Compress the valve springs.
    1. Install the valve collets.
  1. NOTE:
    NOTE:Do not yet tighten.
    Detach Special Tool 303-363 and fit the spark plug.
  1. Repeat the relevant steps on all other cylinders.
  1. Coat the valve tappets with engine oil and insert them.
  1. Fit the camshafts. Camshafts
    For additional information, refer to in this section.

Valve Seals > < Intake Manifold