ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
In-vehicle Repair|Removal > < Transmission Range (TR) Sensor

Mondeo 1997 (08.1996-09.2000)

Automatic Transmission/Transaxle - Output Shaft Speed (OSS) Sensor Mondeo 1997 (08/1996-09/2000)
In-vehicle Repair

Materials
Name
Specification
Automatic transmission fluid
ESP-M2C166-H 
Petroleum jelly
SM-1C115-A 

Removal

  1. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.

  1. Disconnect the output shaft speed (OSS) sensor electrical connector (colored black).

  1. Remove the OSS sensor.
    • Allow the oil to drain into a suitable container.
    • Discard the O-ring seal.

Installation
  1. NOTE:
    NOTE:Install a new OSS sensor O-ring seal.
    Install the OSS sensor.

  1. Connect the OSS sensor electrical connector (colored black).
  1. Lower vehicle.
  1. Start the engine and move the selector lever through all of the ranges, allowing sufficient time for each position to engage.
    • Engage the selector lever in the "P" (park) position.
  1. Check the transmission fluid level.
    For additional information, refer to Preliminary Inspection in this section.
  1. Add automatic transmission fluid, if necessary.

In-vehicle Repair|Removal > < Transmission Range (TR) Sensor