ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Transmission Fluid Cooler Tubes > < Transaxle Cooling

Mondeo 1997 (08.1996-09.2000)

Transmission/Transaxle Cooling - Transmission Fluid Cooler Mondeo 1997 (08/1996-09/2000)
Removal and Installation

Materials
Name
Specification
Automatic transmission fluid
ESP-M2C166-H 
O-ring
 

System overview for the 1,8 and 2,0 Zetec-E engine

 
Item
Part Number
Description
1
-
Feed line
2
-
Connection line
3
-
Return line

Removal

  1. The automatic transmission fluid cooler is integral with the engine cooling system radiator. Removal and installation is therefore identical with the operation 'Radiator - Remove and Install'. For additional information, refer to Section  303-03 Engine Cooling.

  1. Detach the lines for the automatic transmission fluid cooler from the radiator (shown on a radiator removed from the vehicle).
    1. Feed line
    1. Connection line
    1. Return line
    • Unclip the lines from the bracket.

Installation

  1. When installing the automatic transmission fluid cooler, see operation 'Radiator - Remove and Install'. For additional information, refer to Section  303-03 Engine Cooling.
      CAUTION:
      CAUTION:Renew the O-rings of the right-hand fluid cooler.
    • Tighten the threaded line connections at the radiator and at the transmission to 23 Nm.

  1. Check the automatic transmission fluid level.
    For additional information, refer to Fluid Level Check in this section.

Transmission Fluid Cooler Tubes > < Transaxle Cooling