Removal and Installation Removal | -
Detach the front passenger seat. For additional information, refer to Section 501-10 Seating. | | -
Detach and disconnect the electrical connectors. | | -
Remove the driver seat. For additional information, refer to Section 501-10 Seating. | | -
Locally detach the front of the floor covering and release the antenna cable (taped to the floor). | | -
NOTE:Ensure that the wiper motor is in the park position. Remove the wiper arms. - Lift up the plastic caps and loosen the nuts approximately two turns.
- Lift the wiper arms and release them from the taper by moving them side to side.
- Remove the nuts and remove the wiper arms.
| | -
Detach the air cowl grille. | | -
Remove the air cowl grille - Remove the rubber seal.
- Remove the screws.
- Disconnect the air cowl grille at the disconnection point and remove it.
| | -
Remove the antenna. - Detach the antenna from the bracket.
- Detach the bracket.
- Cut the cable ties and remove the antenna.
| Installation | -
To install, reverse the removal procedure. | | |