Anti-Lock Control - Stability Assist - Steering Wheel Rotation Sensor
Mondeo 2001 (10/2000-02/2007)
Removal and Installation
Removal
Remove the steering column. For additional information, refer to Section 211-04 Steering Column.
Remove the steering wheel rotation sensor.
Installation
WARNING:Make sure that the steering wheel rotation sensor drive pins are not damaged, loose or worn. Failure to follow this instruction, may result in personal injury.
Check the steering wheel rotation sensor drive pins.
WARNING:Make sure the steering wheel rotation sensor drive pins are correctly located in the sensor hub. Failure to follow this instruction, may result in personal injury.
Check the steering wheel rotation sensor drive pin to sensor hub for excessive freeplay.
WARNING:Do not use excessive force when installing the steering wheel rotation sensor. Failure to follow this instruction may result in personal injury.
WARNING:Do not use a damaged steering wheel rotation sensor. Failure to follow this instruction may result in personal injury.
Install the steering wheel rotation sensor.
Tighten the screws in the sequence shown.
WARNING:Make sure that the steering wheel rotation sensor is correctly fitted to the support bracket. Failure to follow this instruction, may result in personal injury.
Check the vertical alignment of the steering wheel rotation sensor.
Install the steering column. For additional information, refer to Section 211-04 Steering Column.