In-vehicle Repair Special Tool(s) | Remover/Installer, Cooling Hose Clamp 303-397 (24-003) | Removal | -
Detach the positive crankcase ventilation (PCV) hose and the vacuum hose from the engine upper cover. | | -
Remove the engine upper cover. | | -
Remove the oil level indicator lower retaining bolt. | | -
Remove the intake manifold lower retaining bolt. | | -
Detach the air cleaner outlet pipe from the throttle body (TB). | | -
Detach the accelerator cable. - Detach the inner cable.
- Turn the cable out of the bracket.
- Detach the cable and position it to one side.
| | -
Disconnect the throttle position (TP) sensor and the idle air control (IAC) valve electrical connectors. | | -
Disconnect the brake booster vacuum line from the intake manifold. | | -
Disconnect the electrical connectors. | | -
Detach the engine wiring harness from the intake manifold. | | -
Remove the oil level indicator and tube. | | -
Disconnect the vacuum hoses from the intake manifold. | | -
Disconnect the engine air shut off valve, the manifold absolute pressure (MAP) sensor and the swirl plates solenoid valve electrical connectors. | | -
Remove the intake manifold bolts (engine shown removed for clarity). - Detach the intake manifold from the cylinder head.
| | -
Disconnect the PCV hose from the intake manifold. | | -
Detach the knock sensor (KS) electrical connector from the intake manifold. | | -
Remove the intake manifold. | Installation | -
NOTE:Install new gaskets. To install, reverse the removal procedure. | | |