Removal and Installation Removal | -
Disconnect the engine coolant temperature (ECT) sensor electrical connector. | | -
Disconnect the heated oxygen sensor (HO2S) electrical connector. - Detach the retaining clips from the valve cover.
| | -
Disconnect the fuel injector electrical connectors. | | -
Detach the fuel injector wiring harness retaining clips from the fuel injection supply manifold. | | -
Disconnect the ignition coil pack and ignition coil pack suppressor electrical connectors. | | -
Detach the fuel charging wiring harness retaining clip from the valve cover. | | -
Detach the fuel charging wiring harness retaining clip from the valve cover. | | -
Disconnect the camshaft position (CMP) sensor electrical connector. | | -
Disconnect the crankshaft position (CKP) sensor electrical connector. | | -
Disconnect the oil pressure switch electrical connector. | | -
Detach the fuel charging wiring harness retaining clip from the valve cover. | | -
Disconnect the fuel charging wiring harness electrical connectors. | | -
Remove the fuel charging wiring harness. | Installation | -
To install, reverse the removal procedure. | | |