ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Fuel Injection Supply Manifold - 2.5L Duratec-VE (VE6) > < Throttle Body - 2.5L Duratec-VE (VE6)-3.0L Duratec-SE (VE6)

Mondeo 2001 (10.2000-02.2007)

Fuel Charging and Controls - 2.5L Duratec-VE (VE6)/3.0L Duratec-SE (VE6)/3.0L Duratec-ST (VE6) - Throttle Body—3.0L Duratec-ST (VE6) Mondeo 2001 (10/2000-02/2007)
Removal and Installation

Removal
  1. Remove the air cleaner outlet pipe.
    • Disconnect the intake air bypass hose.
    • Disconnect the positive crankcase ventilation (PCV) hoses.
    • Detach the air cleaner outlet pipe retaining clips.

  1. Disconnect the vehicle speed control cable from the bracket.
    1. Disconnect the vehicle speed control cable from the throttle body.
    1. Detach the vehicle speed control cable.

  1. Disconnect the accelerator cable from the throttle body.
    • Remove the accelerator cable retaining clip.

  1. Detach the accelerator cable from the bracket.

  1. Detach the wiring harness from the throttle body.

  1. Disconnect the throttle position (TP) sensor electrical connector.

  1. Remove the throttle body (intake manifold shown removed for clarity).
    • Discard the gasket.

Installation

  1. NOTE:
    NOTE:Install a new throttle body gasket.
    To install, reverse the removal procedure.

Fuel Injection Supply Manifold - 2.5L Duratec-VE (VE6) > < Throttle Body - 2.5L Duratec-VE (VE6)-3.0L Duratec-SE (VE6)