ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Powertrain Control Module (PCM) > < Intake Manifold Tuning (IMT) Valve

Mondeo 2001 (10.2000-02.2007)

Electronic Engine Controls - 1.8L Duratec-HE (MI4)/2.0L Duratec-HE (MI4) - Crankshaft Position (CKP) Sensor Mondeo 2001 (10/2000-02/2007)
Removal and Installation

General Equipment
Bolt, M6 x 18 mm
CKP alignment tool
  1. Raise and support the vehicle.
    For additional information, refer to: Lifting (100-02 Jacking and Lifting, Description and Operation).

  1. Remove the splash shield

  1. CAUTION:
    CAUTION:Only turn the crankshaft pulley in the normal direction of rotation.
    CAUTION:
    CAUTION:Tighten the M6 x 18 mm bolt finger-tight only.
    Rotate the crankshaft pulley clockwise until the crankshaft pulley timing bolt, M6 x 18 mm can be installed through the crankshaft pulley timing hole into the engine front cover.

4. Remove the components in the order indicated in the following illustration(s) and table(s).

 
Item
Part Number
Description
1
-
CKP sensor electrical connector
2
-
CKP sensor retaining bolts
See Installation Detail
3
-
CKP sensor
See Installation Detail

5. To install, reverse the removal procedure.

Installation Details

Item 3 : CKP sensor

  1. Install the CKP sensor alignment tool to the CKP sensor.

  1. Align the CKP sensor with the crankshaft pulley sensor ring.

Item 2 : CKP sensor retaining bolts

  1. Install the CKP sensor retaining bolts.
  1. Remove the CKP sensor alignment tool.

Powertrain Control Module (PCM) > < Intake Manifold Tuning (IMT) Valve