Removal and Installation Removal | -
Disconnect the roof opening panel motor electrical connector (headliner shown removed for clarity). | | -
Remove the roof opening panel motor. | Installation | -
Remove the roof opening panel guide arm covers. | | -
CAUTION:The guide pins must be aligned centrally between the lugs as shown. Check the alignment of the left-hand and right-hand cable guide (left-hand side shown). | | -
Adjust the left-hand cable guide pin. - Using a suitable screwdriver, move the cable in the direction required.
| | -
Adjust the right-hand cable guide pin. - Using a suitable screwdriver, move the cable in the direction required.
| | -
Install the roof opening panel guide arm covers. | | -
NOTE:Support the roof opening panel motor. Connect the roof opening panel motor electrical connector. | | -
Connect the roof opening panel control switch electrical connector. | | -
CAUTION:This step must be carried out if installing a previously used roof opening panel motor. NOTE:This step is not necessary when installing a new roof opening panel motor. | | -
Disconnect the roof opening panel control switch electrical connector. | | -
Install the roof opening panel motor. | | |