ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
501-20B Supplemental Restraint System > < Rear Center Safety Belt Retractor - 4-Door

Mondeo 2001 (10.2000-02.2007)

Safety Belt System - Safety Belt Shoulder Height Adjuster Mondeo 2001 (10/2000-02/2007)
Removal and Installation

Removal
  1. Detach the front and rear door opening weatherstrips from the B-pillar.
  1. Move the safety belt shoulder height adjuster to its lowest position.

  1. Detach the B-pillar upper trim panel from the B-pillar and position it to one side.
    1. Detach the locating tangs from the B-pillar lower trim panel.
    1. Remove the screw cover.
    1. Remove the screw.

  1. CAUTION:
    CAUTION:The bolt securing the safety belt anchor is held captive by a paper washer. The bolt, spacer and paper washer must remain on the safety belt anchor at all times when the safety belt is detached or removed.
    Detach the safety belt upper anchor from the safety belt shoulder height adjuster.

  1. Remove the safety belt shoulder height adjuster.
    1. Remove the bolt.
    1. Lift the adjuster to detach the locating tang.

Installation

  1. NOTE:
    NOTE:Make sure the safety belt shoulder height adjuster locking control is correctly located on the safety belt shoulder height adjuster.
    To install, reverse the removal procedure.

501-20B Supplemental Restraint System > < Rear Center Safety Belt Retractor - 4-Door