Removal and Installation Special Tool(s) | 303-393 Locking Tool, Flywheel | Removal NOTE:Removal steps in this procedure may contain installation details. | - Remove the following items:
-
Refer to: Clutch Disc and Pressure Plate (308-01A Clutch - Vehicles With: 5-Speed Manual Transmission (iB5), Removal and Installation). -
Refer to: Oil Pan (303-01A Engine - 1.6L Duratec-16V Ti-VCT (Sigma), Removal and Installation). | | -
NOTE:Make sure that new bolts are installed. Torque: Stage 1: 30 Nm Stage 2: 80° | | -
NOTE:New crankshaft rear seal carriers are supplied with an alignment sleeve which must be removed after installation. Torque: 9 Nm | Installation | -
To install, reverse the removal procedure. | | |