ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
General Procedures|Removal and Installation|Removal > < Oil Pump

Mondeo 2007.5 (02.2007-)

Engine - 1.6L Duratec-16V Ti-VCT (Sigma) - Oil Cooler Mondeo 2007.5 (02/2007-)
Removal and Installation

General Equipment
Hose clamp(s)
Hose clamp remover/installer

Removal

NOTE:
NOTE:Removal steps in this procedure may contain installation details.
  1. Refer to: Health and Safety Precautions (100-00 General Information, Description and Operation).
    Refer to: Lifting (100-04 Noise, Vibration and Harshness, Description and Operation).

  1. WARNING:
    WARNING:When releasing the cooling system pressure, cover the coolant expansion tank cap with a thick cloth.
    1. Release the cooling system pressure.
    1. Close the coolant expansion tank cap.

  1. hot
    WARNING:
    WARNING:Be prepared to collect escaping fluids.
    General Equipment: Hose clamp remover/installer
    General Equipment: Hose clamp(s)
    Torque: 15 Nm

  1. Torque: 55 Nm

Installation

  1. To install, reverse the removal procedure.
  1.  
    • Check the oil level.
    • Refer to: Cooling System Draining, Filling and Bleeding (303-03A Engine Cooling - 1.6L Duratec-16V Ti-VCT (Sigma), General Procedures).

General Procedures|Removal and Installation|Removal > < Oil Pump