ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Exhaust Manifold to Exhaust Gas Recirculation (EGR) Valve Tube > < Exhaust Gas Recirculation (EGR) Valve

Mondeo 2007.5 (02.2007-)

Engine Emission Control - 2.0L Duratorq-TDCi (DW) Diesel - Exhaust Gas Recirculation (EGR) Cooler Mondeo 2007.5 (02/2007-)
Removal and Installation

General Equipment
Hose clamp remover/installer

Removal

NOTE:
NOTE:Removal steps in this procedure may contain installation details.
  1. Drain the cooling system.
    Refer to: Cooling System Draining, Filling and Bleeding (303-03E Engine Cooling - 2.0L Duratorq-TDCi (DW) Diesel, General Procedures).

  1. General Equipment: Hose clamp remover/installer
    Torque: 10 Nm

  1. NOTE:
    NOTE:Note the orientation of the clamp to aid installation.
    NOTE:
    NOTE:The gasket is to be reused unless damaged.
    1. Discard the clamp.
    1. Torque: 30 Nm
    1. Torque: 10 Nm
    1. Torque: 10 Nm

Installation

  1. NOTE:
    NOTE:Make sure that a new clamp is installed.
    NOTE:
    NOTE:Make sure that the clamp is installed to the same orientation as when removed.
    To install, reverse the removal procedure.

Exhaust Manifold to Exhaust Gas Recirculation (EGR) Valve Tube > < Exhaust Gas Recirculation (EGR) Valve