| General Procedures | | -
Body dimensions, 5-door version (quick measurements using the Allvis system) - All dimensions are measured from the middle of the hole or bolt head or from the edge of the panel, using the Allvis system, with component assemblies installed.
- A tolerance of ± 3 mm applies to all measurements given. All detailed illustrations correspond to the left-hand side of the vehicle.
- Points 01 and 02 are the zero points of the diagonal measurements.
- Measuring point 4 is used as the zero point for additional diagonal measurements.
Allvis specifications | Point of measurement | adapter | Height setting of the test probes | | 1 | 25 mm (probe) | 330 mm | | 2 | 25 mm (probe) | 190 mm | | 3 | 25 mm (probe) | 50 mm | | 4 | | | | 5 | 35 mm (probe) | 160 mm | | 6 | 25 mm (probe) | 170 mm | | 7 | 25 mm (probe) | 270 mm | | 8 | 25 mm (probe) | 350 mm | | 9 | 25 mm (probe) | 350 mm | | | | -
Body dimensions, 4-door and wagon versions (quick measurements using the Allvis system) - All dimensions are measured from the middle of the hole or bolt head or from the edge of the panel, using the Allvis system, with component assemblies installed.
- A tolerance of ± 3 mm applies to all measurements given. All detailed illustrations correspond to the left-hand side of the vehicle.
- Points 01 and 02 are the zero points of the diagonal measurements.
- Measuring point 4 is used as the zero point for additional diagonal measurements.
Allvis specifications | Point of measurement | adapter | Height setting of the test probes | | 1 | 25 mm (probe) | 330 mm | | 2 | 25 mm (probe) | 190 mm | | 3 | 25 mm (probe) | 50 mm | | 4 | | | | 5 | 35 mm (probe) | 160 mm | | 6 | 25 mm (probe) | 170 mm | | 7 | 25 mm (probe) | 260 mm | | 8 | 25 mm (probe) | 350 mm | | 9 | 25 mm (probe) | 350 mm | | | |
