Mustang V6-4.0L (2008)
7. Install the pressure sensor onto the cushion frame bracket, making sure the retaining tab is completely engaged.
-
When installed correctly, an audible click will be heard and the pressure sensor will not be able to be removed from its bracket without
disengaging the retaining tab.
8. Attach any seat wire harness routing pin-type retainers to the cushion frame as noted during removal.
Power driver seat
9. Install the seat control switch and the lumbar control switch into the cushion side shield.
-
Install the seat control switch knob.
10. Position the cushion side shield to the cushion frame and connect the seat control switch and lumbar control switch.
All seats
11. Position the cushion foam pad and trim cover to the cushion frame.
12. Install the seat track.
13. Install the seat backrest.
14. Install the seat.
15. Repower the SRS. If the passenger seat has been serviced, do not prove out the SRS at this time.
Passenger seat
16. WARNING:
-
Install a new occupant classification sensor (OCS) system service kit as a complete assembly. Never install only part of the kit
components. Failure to follow this instruction may result in incorrect operation of the OCS system and increases the risk of serious
personal injury or death in a crash.
-
Make sure the front passenger seat repair is complete, the seat and all attached components (head restraint, seat side shield, etc.) are
correctly assembled, and the seat is correctly installed to the vehicle before carrying out the System Reset. Failure to follow these
instructions may result in incorrect operation of the occupant classification sensor (OCS) system and increases the risk of serious
personal injury or death in a crash.
CAUTION:
-
To prevent system failure, it is necessary to carry out the occupant classification sensor (OCS) system reset when a front passenger
seat cushion is disassembled, a new trim cover installed or an OCS system service kit is installed. A scan tool is used to carry out the
OCS system reset command.
-
To prevent system failure, the following precautions must be taken before carrying out the occupant classification sensor (OCS)
system reset:
-
Make sure the voltage to the occupant classification system module (OCSM) is above 8.0 volts and less than 18.0 volts.
-
Make sure the OCS is not at a temperature below 6°C (42°F) or above 36°C (97°F) when initiating the OCS system reset process.
If the vehicle has been exposed to extreme cold or hot temperatures, the vehicle must be exposed and kept at a temperature within
the limits, 6°C to 36°C (42°F to 97°F) for a minimum of 30 minutes.
-
Make sure nothing is present on the passenger seat before carrying out the OCS system reset and nothing is placed on the seat
