Mustang V6-4.0L (2008)
6. Install the special tools.
7. Remove the RH engine mount nut.
8. Remove the LH engine mount nut.
9. Remove the oil pump screen and pickup tube.
10. CAUTION: Do not allow the steering wheel to rotate while the steering column intermediate shaft is disconnected or damage to the
clockspring can result. If there is evidence that the wheel has rotated, the clockspring must be removed and recentered. For additional
information, refer to Air Bag Systems.
Remove the bolt and detach the steering column intermediate shaft from the steering gear.
11. Remove the bolt and detach the power steering pressure (PSP) tube bracket from the crossmember.
12. Remove the 2 steering gear-to-crossmember bolts and detach the gear from the crossmember.
13. Remove the starter. For additional information, refer to Starting System.
14. NOTE: The cylinder block cradle is shown removed for clarity. Note the location of the 2 Torx(R) head bolts at the rear of the cylinder block
cradle.
Remove the 2 cylinder block cradle rear Torx(R) bolts.
15. Remove the 20 bolts and 2 nuts along the outside of the cylinder block cradle.