Mustang V6-4.0L (2008)
16. NOTE: Note the location of the 2 silver-colored bolts that have washer seals. They must be installed in the same position with new washer seals.
Remove the 8 cylinder block cradle inner bolts and the 2 washer seals.
^
Discard the washer seals.
17. Using the special tools, raise the engine and then remove the lower block cradle.
Installation
1. CAUTION: Failure to back off the set screws can result in damage to the cylinder block cradle.
Back the set screws off until they are below the cylinder block cradle boss.
2. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These
tools cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
NOTE: Gasket material as well as silicone sealant may be present in the cavities in the main bearing cap. This material must be removed
completely prior to assembly.
Clean the gasket mating surfaces, making sure all the sealant is removed from the cavities on the rear main bearing cap. To clean the sealing area,
use silicone gasket remover and metal surface prep. Follow the directions on the packaging.