Mustang V6-4.0L (2008)
Condenser HVAC: Service and Repair
CONDENSER CORE
Removal and Installation
NOTE: Installation of a new suction accumulator is not required when repairing the A/C system, except when there is physical evidence of
contamination from a failed A/C compressor or damage to the suction accumulator.
All vehicles
1. Recover the refrigerant.
2. With the vehicle in NEUTRAL, position it on a hoist.
3. Remove the condenser inlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal.
-
To install, tighten to 8 Nm (71 lb-in).
5.4L (4V) vehicles
4. Remove the front bumper cover.
5. NOTE: RH air deflector shown, LH similar.
Remove the pin-type retainers and detach the RH and LH air deflectors from the condenser core.