Mustang V6-4.0L (2008)
Hose/Line HVAC: Service and Repair
Compressor Manifold and Tube Assembly
COMPRESSOR MANIFOLD AND TUBE ASSEMBLY
Removal and Installation
NOTE: Installation of a new suction accumulator is not required when repairing the A/C system, except when there is physical evidence of
contamination from a failed A/C compressor or damage to the suction accumulator.
1. Recover the refrigerant.
2. Loosen the compressor manifold bolt and detach the compressor manifold.
-
Discard the O-ring seals.
-
To install, tighten to 21 Nm (15 lb-ft).
3. Remove the compressor manifold and tube bracket nut.
-
To install, tighten to 25 Nm (18 lb-ft).
4. Disconnect the pressure transducer electrical connector.
5. Disconnect the suction accumulator outlet fitting.
-
Discard the O-ring seals.