Mustang V6-4.0L (2008)
inboard I outboard. Loosen nut. Use a 4 mm hex drive to wind the jack screw as needed. Tighten nuts. (Figures 1 and 2)
3.
Adjust quarter glass so that a constant 5/32"-1/4" (4-6 mm) gap exists between the division bar and the door glass. Also, adjust so that the glass is
inset 5/32" - 1/4" (4-6 mm) inside the weatherstrip retainer. Apply tape to top exterior side of quarter glass. Mark a 5/32" - 1/4" (4-6 mm) line on
the tape as a visual aid in adjusting the glass inset to weatherstrip retainer. Use quarter glass attaching screws to adjust the glass. Loosen both
screws and move the glass in plane as needed. (Figures 3 - 5)
4.
Tighten screws and install the rear side rail weatherstrip.
