Mustang V8-4.6L (2009)
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new SJB. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CLEAR the DTCs. REPEAT the
network test with the scan tool.
-------------------------------------------------
I22 CHECK FOR CORRECT IC OPERATION
-
Disconnect the IC connector.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the IC connector and make sure it seats correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new IC. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CLEAR the DTCs. REPEAT the
network test with the scan tool.
-------------------------------------------------
I23 CHECK FOR CORRECT SDARS MODULE OPERATION
-
Disconnect the SDARS module connector.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the SDARS module connector and make sure it seats correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new SDARS module. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CLEAR the DTCs. REPEAT the
network test with the scan tool.
-------------------------------------------------
I24 CHECK FOR CORRECT ACM OPERATION
-
Disconnect all of the ACM connectors.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect all of the ACM connectors and make sure they seat correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?