Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
cylinder block and crankshaft rear oil seal retainer meets cylinder block. Position oil pan on cylinder block and install 16 bolts. Tighten bolts in
sequence to 20-30 Nm (15-22 ft. lbs.).
9. Install oil bypass filter.
10. Connect engine control sensor wiring to low oil level sensor.
11. Raise front crossmember and install retaining bolts finger-tight.
12. Remove Rotunda Powertrain Lift 014-00765 or equivalent.
13. Align front crossmember using marks made during removal as a guide. Tighten front crossmember retaining bolts to 113-153 Nm (84-112 ft. lbs.).
14. Connect front wheel spindle to ball joints. Refer to Steering and Suspension.
15. Connect steering shaft to steering gear. Tighten pinch bolt to 28-40 Nm (21-29 ft. lbs.).
16. Connect both sway bar links. Refer to Steering and Suspension.
17. Install front engine support insulator retaining nuts. Tighten to 128-172 Nm (95-126 ft. lbs.).
18. Install front wheels and tires.
19. Remove safety stands and lower vehicle.
20. Remove three bar engine support and lifting eyes.
21. Fill engine with clean engine oil meeting Ford specification WSS-M2C153-F.
22. Install transmission.
23. Connect battery ground cable.
24. Start engine.
25. Raise vehicle and inspect for leaks.
26. Lower vehicle.
27. Turn engine OFF.
28. Wait 10 minutes, then check oil level.
