Mustang Cobra V8-4.6L DOHC VIN V (2000)
5.
Remove the safety belt retractor retaining bolt(s), then remove the safety belt retractor(s) and web guide(s) as an assembly. See Figure 15.
6.
Install the new safety belt retractor(s). Tighten the retaining bolt(s) to 40 Nm (30 lb-ft).
7.
Install the front lining board.
8.
Close the trunk.
9.
Install the rear seat safety belt lower anchor bolt(s). Tighten the anchor bolt(s) to 40 Nm (30 lb-ft).
10.
Install the rear seat cushion.
Taurus/Sable Sedan
REAR SEAT SAFETY BELT RETRACTORS
NOTE:
If both rear seat safety belt retractors require replacement, remove the driver-side and passenger-side components during the same step.
1.
Remove the rear seat cushion and backrest cushion.