Mustang Cobra V8-4.6L DOHC VIN V (2000)
10.
Separate the toe link from the rear suspension knuckle using Steering Arm Remover (T64P-9171-A). See Figure 3.
11.
Place a reference mark for reassembly on the upper ball joint cam bolt and the upper control arm. See Figure 4.
12.
Hold the cam bolt with a wrench and remove the nut. Remove the cam bolt and transfer the reference mark onto a new cam bolt, then discard the
original cam bolt and nut. See Figure 4.
13.
Rotate the top of the knuckle towards the front of the vehicle and remove the toe link from the knuckle.