Mustang GT V8-4.6L SOHC VIN X (1998)
10. NOTE: Use a shop cloth to protect pan-to-case surface.
Remove manual lever shaft retaining pin.
11. Using a 13/16-inch open-end wrench on the inner nut and a 12 mm wrench on the manual control lever shaft flats, loosen the inner nut.
Slide manual control lever partially out of the case to complete removal of the inner nut from manual control lever. Remove manual control lever
from case.
12. NOTE: Do not damage bore with the prying tool.
Using a screwdriver on the manual control lever seal lower edge, carefully pry manual control lever seal out of case bore.
INSTALLATION
1. Install new manual control lever seal using Shift Lever Seal Replacer 307-050 (T74P-77498-A).
2. Position manual valve detent lever and parking lever actuating rod into case. Parking lever actuating rod must be positioned over parking pawl.
3. Slide manual control lever into case and position through detent. Install nut and tighten to 26-37 Nm (20-27 ft. lbs.).
Install manual lever shaft retaining pin.