ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Condenser Fan > < Air Conditioning - Approved Flushing Procedures
Page 2
background image

2.

Remove the flushing solvent from the A/C system. In this step, pressurized air (90-125 psi/620-862 kPa) is used to push and evaporate any
remaining flush solvent from the heat exchangers.

Only Rotunda Item No. 014-00990 A/C Flushing kit which includes 014-00991 A/C Flusher, 014-00992 A/C Flusher Filling Kit. and F4AZ-19579-A
A/C Flushing Solvent (case of 4 gallons/15 L), is approved for use on Ford vehicles. No other flushing device or solvent is approved by Ford Motor
Company for flushing A/C systems. The use of other equipment or solvent may cause damage to the A/C system and the flushing unit.

Minimum time for flushing is 15 minutes and minimum time for air flushing is 30 minutes. Failure to continue air purge for the entire 30 minutes as
specified may result in residual amounts of flush solvent contaminating the A/C system. Residual flush solvent in a functioning A/C system may lead to
A/C system failure.

Do not flush through orifice tubes. TXVs, accumulator/driers, receiver/driers, mufflers or hoses. Internal plumbing and material make-up of these
components make it impossible to properly remove the debris and/or residual flushing solvent.

One (1) gallon (3.8 L) of Ford A/C System Flushing Solvent is used in this device and is intended for one (1) vehicle only. It may be used to flush both
heat exchangers on an individual vehicle, but under no circumstances should it be used on more than one (1) vehicle. The filter used when flushing is
also intended for use on one (1) vehicle only.

NOTE

DURING THE FLUSHING PROCESS, THIS MATERIAL MAY COLLECT RESIDUE FROM THE A/C SYSTEM, WHICH MAY INCLUDE
CFC-12. DISPOSE OF THE SOLVENT AND FILTER IN ACCORDANCE WITH FEDERAL, STATE AND LOCAL REGULATIONS.

Use of A/C system filter kits as prescribed in TSB 94-15-5 is optional if the A/C system is flushed. Filter kit use is recommended after flushing if the
system is highly contaminated. If the hoses are clogged with debris, hose replacement is required.

Always remember to match oil properly, replace the accumulator/drier and orifice tube, or TXV and receiver/drier when servicing an A/C system with a
compressor or desiccant failure.

The following vehicles require A/C system flushing with retrofit kits to remove mineral oil for capacity reasons.

^

1993 Probe 2.0L and 2.5L

^

1988-90 Escort 1.9L EFI

^

1989-93 Thunderbird Super Coupe

^

1986-92 Mark VII

^

1991-93 Capri 1.6L and 1.6T

^

1988-93 Festiva 1 .3L

^

1987-90 Tracer 1.6L

^

1985-89 XR4Ti

^

1988-89 Scorpio

OTHER APPLICABLE ARTICLES: 94-15-5
SUPERSEDES: 95-8-1
WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage For 1991-95 Lincolns And All Other 1992-95
Models

OPERATION

DESCRIPTION

TIME

951804A

Flush Evaporator

1.0 Hr.

951804B

Flush Condenser

1.0 Hr.

DEALER CODING

CONDITION

BASIC PART NO.

CODE

19703

49

OASIS CODES: 208000, 208200, 208999

Condenser Fan > < Air Conditioning - Approved Flushing Procedures