Check the evenness of the cylinder head mounting face using a steel straightedge .
Place the steel straightedge across all combustion chamber recesses and check at three points using the feeler gauge .
Place a steel rule longitudinally over the cylinder head and check all areas between the combustion chamber recesses.
Place the steel straightedge diagonally across the cylinder head and check all areas between the combustion chamber recesses; the distortion of the mating face must not be more than 0,05 mm.
Check the evenness of the upper surface of the cylinder head.
Place a steel rule longitudinally across all the mounting faces of the camshaft bearing caps. Check all mounting faces with a feeler gauge. The distortion of the mounting faces must not exceed 0,05 mm.