ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Radiator > < Thermostat

Puma 1998 (06.1997-12.2001)

Engine Cooling - Water Pump Puma 1998 (06/1997-12/2001)
Removal and Installation

Removal

  1. Disconnect the battery ground cable.
  1. Drain the cooling system.
    For additional information, refer to Cooling System Draining, Filling and Bleeding in this section.

  1. Loosen the water pump pulley retaining bolts.
  1. Remove the generator. For additional information, refer to Section  414-02 Generator and Regulator.

  1. Remove the water pump pulley.

  1. Remove the water pump.

Installation
  1. NOTE:
    NOTE:Install a new water pump gasket.
    To install, reverse the removal procedure.

  1. Refill the cooling system.
    For additional information, refer to Cooling System Draining, Filling and Bleeding in this section.

Radiator > < Thermostat